Comparison and analysis of 10 common cleaning methods for ultrasonic equipment
Ultrasonic cleaning, brushing and other 10 kinds of common workpiece cleaning way of comparative analysis, the purpose of cleaning is to remove the washed impurities, dirt and grease and other dirt objects and objects to achieve the cleaning effect and the clean degree. It is a process of some external factors that are used in the physical and chemical reactions of the object surface or the internal occurrence.. The different parts of the workpiece and the role of the different cleaning process of the media, the force, the effect of the factors vary. Select the cleaning process according to the cleaning work and set, the following Jining branch strong ultrasound on 10 common workpiece cleaning methods for a brief description:
1, ultrasonic cleaning, which is a new way of cleaning, strict sense said ultrasonic cleaning belong to physical cleaning, the cleaning method is by ultrasonic wave in the liquid cavitation continuously produced rather than 1000 large pressure transient pressure impact the workpiece table surface and liquid can penetrate into the inside of the workpiece and to attain the goal of cleaning, the cleaning with clean degree high, fast cleaning speed, wide range of application, labor intensity is low and environmental characteristics. The cleaning technology is mainly used in the production and laboratory, and the civilian products are not popularized.
2, immersion cleaning, belongs to the chemical cleaning, by in a liquid with a certain amount of cleaning agents soak in the dirt and cleaning agent, and then in the cleaning, the cleaning low cost, usually need to soak a long time, because it is the application of chemical reaction has certain limitations.
3, jet cleaning, through the groove pressure jet device to improve the cleaning fluid for the workpiece pressure and achieve the purpose of the wash.
4, the jet wash, and the jet wash is roughly the same, different is from the groove of the liquid jet.
5, scrub, soak or spray in the liquid at the same time, with the brush were the ordure brush, mainly rely on friction cleaning, usually with spray and immersion cleaning, low cost, but high labor intensity, cleaning degree is not high.
6, spray cleaning, and jet cleaning is different, in the groove of the jet tube, the liquid jet on the workpiece
7, the vacuum cleaning, in the washing tank internal negative pressure, improve the cleaning agent penetration effect
8, spray cleaning, spray pipe in the cleaning tank, the cleaning agent spray to improve the efficiency of the cleaning agent on the surface of the workpiece
9, the rotary cleaning, through the washing tank with the rotating device, through the rotation to achieve the purpose of mixing
10, shaking the cleaning, through the washing tank with a shake device, through the upper or lower or left and right to improve the cleaning efficiency of the.